Special Offer for February 2020 - Was £214.99
The Enigma Broadcast 2m high power amplifier v2 is perfect for those wishing to increase their presence on the 2m band. With an output of 300-350W with an input drive of only 2W, this compact module has several novel features and excellent specifications.
This new version has several improvements and extra customer-requested features when compared to the previous version : Improved bias thermal tracking, PTT LED indication plus dual-mode bias disable to save power in linear mode during idle.
This module is suitable for those wishing to build their own home-brew amplifier but lack the experience or test equipment to build and set up a full kit themselves.
The amplifier is supplied completely assembled and tested on a heatsink. For a finished product you will need to add a case, a fan of at least 50cfm, 500W/ 48-50V power supply, coaxial relays, coax cable and connectors.
For those who wish to build this amplifier from scratch, a kit is also available here.
-Fully assembled and tested amplifier building-block
-High quality components used throughout
-Latest high-ruggedness MRFE6VP6300H RF mosfet
-High efficiency design
-Broadband, requires no tuning
-On-board low pass filter. Excellent spectral purity
-On-board directional coupler and precision thermistor for SWR and temperature monitoring
-Bias shutdown for PTT
-Temperature compensated mosfet bias
-Suitable for FM & SSB
-Power Gain: >22dB @48V/ 50mA bias (2W input required for >300W output)
-Efficiency: Approx. 70% @350W/ 48V (FM mode)
-Harmonic output: <-70dBc, 140-150MHz
-Current draw: Typical 10A at 48V
-Supplied tested and set-up for FM use, SSB will require re-adjustment of bias
-Mismatch ruggedness: >SWR 65:1. Tested into open and short circuit loads at the output without damage.
-Size: 150 (L) x 100 (W) x 75 (H)mm (mounted on Enigma HS150 heatsink).
-Voltage outputs via an edge connector for thermal and SWR monitoring, suitable for connection to a microcontroller
-Bias shutdown for PTT (dual mode, either ground or +5-12V input to disable bias)
-LED indicators for +50V Supply and PTT bias on.
-Supplied with full instructions & technical support via email.